LSM303D 3D Compass and Accelerometer Carrier with Voltage Regulator

0 reviews  (0/5 ) 0 reviews  •  Write a review
Product Code: 91186
Availability: SOLD OUT Views: 19768
Product Description
  • 3 magnetic field channels
  • 3 acceleration channels
  • 16 bit data output
  • ±2, ±4, ±6, ±8, or ±16 g/gauss selectable sensitivity
  • SPI/I2C Serial interfaces
$9.00
Qty:

Shipping Options to United States

Select Country:
* Region / State:

LSM303D 3D Compass and Accelerometer Carrier with Voltage Regulator info

LSM303D 3D Compass and Accelerometer Carrier with Voltage Regulator is a compact (0.4″ × 0.9″) breakout board for ST’s LSM303D e-compass module, a single IC featuring a 3-axis digital linear acceleration sensor and 3-axis digital magnetic sensor. The LSM303D is a great IC, but its small package makes it difficult for the typical student or hobbyist to use. It also operates at voltages below 3.6 V, which can make interfacing difficult for microcontrollers operating at 5 V. This carrier board addresses these issues by incorporating additional electronics, including a 3.3 V voltage regulator and level-shifting circuits.

The LSM303D has many configurable options, including dynamically selectable sensitivities for the accelerometer and magnetometer, a choice of output data rates, and two independently-programmable external inertial interrupt pins. The magnetometer and accelerometer can be individually turned on and off to save power. The six independent magnetic and acceleration readings (sometimes called 6DOF) are available through a digital interface, which can be configured to operate in either I²C (TWI) or SPI mode.

LSM303D 3D Compass and Accelerometer Carrier with Voltage Regulator includes a low-dropout linear voltage regulator that provides the 3.3 V required by the LSM303D, which allows the sensor to be powered from a 2.5–5.5 V supply. The regulator output is available on the VDD pin and can supply almost 150 mA to external devices. The breakout board also includes a circuit that shifts the I²C clock and data lines to the same logic voltage level as the supplied VIN, making it simple to interface the board with 5 V systems, and the board’s 0.1″ pin spacing makes it easy to use with standard solderless breadboards.

 

LSM303D 3D Compass and Accelerometer Carrier with Voltage Regulator - General Specifications

  • 3 magnetic field channels
  • 3 acceleration channels
  • 16 bit data output
  • ±2, ±4, ±6, ±8, or ±16 g/gauss selectable sensitivity
  • SPI/I2C Serial interfaces

 

LSM303D 3D Compass and Accelerometer Carrier with Voltage Regulator - Technical Specifications

  • Dimensions: 10 × 23 × 3 mm
  • Weight: 0.6 g (0.02 oz)
  • Operating voltage: 2.5 V to 5.5 V
  • Supply current: 5 mA
  • Output format (I²C/SPI):
    • Accelerometer: one 16-bit reading per axis
    • Magnetometer: one 16-bit reading per axis
  • Sensitivity range (configurable):
    • Accelerometer: ±2, ±4, ±6, ±8, or ±16 g
    • Magnetometer: ±2, ±4, ±8, or ±12 gauss

 

Videos

 

 

Documents

LSM303D datasheet

 

References

 

Pololu Web Sitehttps://www.pololu.com/product/2127

There are no reviews for this product.
Write a review Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: