MQ2 Flammable Gas/Smoke Sensor

0 reviews  (0/5 ) 0 reviews  •  Write a review
Product Code: 91444
Availability: SOLD OUT Views: 32220
Product Description
  • Good sensitivity to flammable gas in wide range
  • High sensitivity to LPG, Propane and Hydrogen
  • Long life and low cost
  • Simple drive circuit
$2.00
Qty:

Shipping Options to United States

Select Country:
* Region / State:

MQ2 Flammable Gas/Smoke Sensor info

MQ2 Flammable Gas/Smoke Sensor detects the concentrations of flammable gas in the air and ouputs its reading as an analog voltage. The sensor can measure concentrations of 300 to 10,000 ppm for CO and 300 to 10000ppm for flammable gas. The sensor can operate at temperatures from -20 to 50°C and consumes less than 150 mA at 5 V.

Connecting five volts across the heating (H) pins keeps the sensor hot enough to function correctly. Connecting five volts at either the A or B pins causes the sensor to emit an analog voltage on the other pins. A resistive load between the output pins and ground sets the sensitivity of the detector. The resistive load should be calibrated for your particular application using the equations in the datasheet, but a good starting value for the resistor is 20 kΩ.

 

MQ2 Flammable Gas/Smoke Sensor - General Specifications

  • Good sensitivity to flammable gas in wide range
  • High sensitivity to LPG, Propane and Hydrogen
  • Long life and low cost
  • Simple drive circuit

 

MQ2 Flammable Gas/Smoke Sensor - Technical Specifications

  • Detection Gas: Flammable Gas and Smoke
  • Concentration: 300-10000ppm Flammable Gas
  • Supply Voltage: <24V
  • Heater Voltage: 5.0V ± 0.2V (High)
  • Load Resistance: Adjustable
  • Heater Resistance: 31Ω ± 3Ω
  • Heater Consumption: <900mW

 

Videos

 

Documents

MQ-2 Datasheet

 

There are no reviews for this product.
Write a review Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: