Motor Control Shield - L293D - Motor Drive Expansion Board for Arduino OEM

0 reviews  (0/5 ) 0 reviews  •  Write a review
Product Code: 91120
Availability: SOLD OUT Views: 31384
Product Description
  • Two L293D Motor driver chips
  • Four H-Bridges
  • 0.6A per bridge (1.2A peak)
  • Thermal shutdown protection,
  • Internal kickback protection diodes
  • Up to 4 bi-directional DC motors
  • Up to 2 stepper motors
  • Pull down resistors to keep motors disabled during power-up
  • Separate logic and motor power connections
  • Terminal block connectors for motors and power
$5.00
Equivalent Products
  • $ 34.26
    Arduino Motor Shield V3 - Original - Boxed
  • Qty:

    Shipping Options to United States

    Select Country:
    * Region / State:

    Motor Control Shield - L293D - Motor Drive Expansion Board for Arduino OEM info

    Motor Control Shield  -  L293D contains two L293D motor drivers and one 74HC595 shift register. The shift register expands 3 pins of the Arduino to 8 pins to control the direction for the motor drivers. The output enable of the L293D is directly connected to PWM outputs of the Arduino.

    To increase the maximum current, the L293D allows extra chips with "piggyback". Piggyback is soldering one or two or three extra L293D drivers on top of the L293D drivers on the board to increase the maximum current. L293D allows parallel operation.

    Motor Control Shield  -  L293D is able to drive 2 servo motors. The servo motors use the +5V of the Arduino board. The voltage regulator on the Arduino board could get hot. To avoid this, the newer motor Shields have connection points for a seperate +5V for the servo motors.

     

    Motor Control Shield  -  L293D - Product Description

    • Two L293D Motor driver chips
    • Four H-Bridges
    • 0.6A per bridge (1.2A peak)
    • Thermal shutdown protection,
    • Internal kickback protection diodes
    • Up to 4 bi-directional DC motors
    • Up to 2 stepper motors
    • Pull down resistors to keep motors disabled during power-up
    • Separate logic and motor power connections
    • Terminal block connectors for motors and power

     

    Motor Control Shield  -  L293D - Technical Specifications

    • Motor Voltages from 4.5VDC to 16VDC
    • 0.6A per bridge (1.2A peak)
    • Thermal shutdown protection
    • Internal kickback protection diodes.
    • Four H-Bridges
    • 2 connections for 5V 'hobby' servos
    • Size:6.8cm x 5.5cm x 2cm

     

    Videos

     

     

    Documents

    L293D Datasheet

     

    References

     

    There are no reviews for this product.
    Write a review Your Name:


    Your Review:Note: HTML is not translated!

    Rating: Bad           Good

    Enter the code in the box below: