Arduino Wireless Shield - XBee SD Shield

0 reviews  (0/5 ) 0 reviews  •  Write a review
Product Code: 91148
Availability: SOLD OUT Views: 9304
Product Description
  • Allows an Arduino board to communicate wirelessly using a wireless module
  • Communicate up to 100 feet indoors or 300 feet outdoors
  • Compatible with all XBee modules
  • SD card slot
$20.00
Equivalent Products
  • $ 20.06
    Arduino Wireless Shield - XBee Shield
  • Qty:

    Shipping Options to United States

    Select Country:
    * Region / State:

    Arduino Wireless Shield - XBee SD Shield info

    The Arduino Wireless Shield allows an Arduino board to communicate wirelessly using a wireless module. It is based on the Xbee modules from Digi, but can use any module with the same footprint. The module can communicate up to 100 feet indoors or 300 feet outdoors (with line of sight). It can be used as a serial/usb replacement or you can put it into a command mode and configure it for a variety of broadcast and mesh networking options. The shields breaks out each of the Xbee's pins to a through hole solder pad. An on-board swith allows the wireless module to communicate with the USB to serial converter or with the microntroller.

    Included on board is a SD card slot. When using the SD Library to access the card, Pin 4 is CS and cannot be used otherwise. SPI also relies on pins 11, 12, and 13 for communication.

     

    Arduino Wireless Shield - XBee SD Shield - General Specifications

    • Allows an Arduino board to communicate wirelessly using a wireless module
    • Communicate up to 100 feet indoors or 300 feet outdoors
    • Compatible with all XBee modules
    • SD card slot

     

    Arduino Wireless Shield - XBee SD Shield - Technical Specifications

     

     

    Videos

     

    Documents

    EAGLE files

    Schematic

     

    References

     

    There are no reviews for this product.
    Write a review Your Name:


    Your Review:Note: HTML is not translated!

    Rating: Bad           Good

    Enter the code in the box below: